Datalogic PowerScan PM8300

Enter Configuration Exit and Save Configuration
60 PowerScan™ PD9330/PBT9300/PM9300
LAST CODE SHOWN TIMEOUT
After the CODE transmission, the last code read will be shown on the display
for a configurable timeout (LAST CODE SHOWN TOUT).
NOTE: Just as in the settings for the standard Powerscan™, the display has
an active timeout before going in OFF state. This timeout has a higher prior-
ity than the LAST CODE SHOWN TOUT, so the two parameters should be
c
ombined to get the desired result.
Last code shown timeout = disable
Last code shown timeout = 1 second
Last code shown timeout = 2 second
DEFAULT
Last code shown timeout = 5 second
Last code shown timeout = 10 second