Enter Configuration Exit and Save Configuration
32
PowerScan™ PD9330/PBT9300/PM9300
RS-485 NETWORK
RS-485 Network = disable RS-485 network
RS-485 Network = enable RS-485 slave
RS-485 Network = enable RS-485 master
If a BC-8060 cradle is errantly configured as a Slave but not connected to a network, it
may not be able to receive further commands from the reader. In this case it can be
reconfigured by executing the bind procedure, which returns the cradle to Stand-alone
configuration.
To Next Page
Loading...
