40
PowerScan™ PD9330/PBT9300/PM9300
CODE IDENTIFIER TABLE
CODE
AIM
STANDARD
DATALOGIC
STANDARD
CUSTOM
2/5 interleaved ] I y N
2/5 industrial ] X y P ] X y P
2/5 normal 5 bars ] S y O
EAN 8 ] E 4 A
EAN 13 ] E 0 B
UPC A ] X y C
UPC E ] X y D
EAN 8 with 2 ADD ON ] E 5 J
EAN 8 with 5 ADD ON ] E 6 K
EAN 13 with 2 ADD ON ] E 1 L
EAN 13 with 5 ADD ON ] E 2 M
UPC A with 2 ADD ON ] X y F
UPC A with 5 ADD ON ] X y G
UPC E with 2 ADD ON ] X y H
UPC E with 5 ADD ON ] X y I
Code 39 ] A y V
Code 39 Full ASCII
CODABAR ] F y R
ABC CODABAR ] X y S
Code 128 ] C y T
EAN 128 ] C y k
ISBT 128 ] C4 f
Code 93 ] G y U
CIP/39 ] X y Y
CIP/HR
Code 32 ] X y X
MSI ] M y Z
Code 11 ] H y b
GS1 DataBar™ Expanded Linear and Stacked ] e 0 t
GS1 DataBar Limited ] e 0 v
GS1 DataBar 14 Linear and Stacked ] e 0 u
• AIM standard identifiers are not defined for all codes: the X identifier is
assigned to the code for which the standard is not defined. The y value
depends on the selected options (check digit tested or not, check digit tx
or not, etc.).
• When customizing the Datalogic Standard code
identifiers, 1 or 2 identifier
characters can be defined for each code type. If only 1 identifier character
is required, the second character must be selected as FF (disabled).
• The code identifier can be singly disabled
for any code by simply selecting
FF as the first identifier character.
• Write in the Custom character identifiers in the table above for your
re
cords.
To Next Page
Loading...
Need help?
General
