Datalogic QuickScan QS6500 User Manual

Interface Features
Product Reference Guide 4-33
Keyboard Wedge/USB Keyboard — cont.
Intercharacter Delay
NOTE
This feature does not apply to the USB Keyboard
interface.
START
MODE BARCODE
This delay is inserted after each data character trans-
mitted. If the transmission speed is too high, the sys-
tem may not be able to receive all characters. You may
need to adjust the delay to make the system work prop-
erly. Selectable from 00 to 255 in 10msec increments.
Use hexidecimal (range: 00 to FF hexidecimal) to set
the delay.
To configure this feature, scan the “START” bar code
above to place the unit in Programming Mode, then the
“Set Intercharacter Delay,” followed by the digits from
the Alphanumeric table in
Appendix B, Alpha-
Numeric Pad
representing your desired length.
Accept your selection by scanning the “SET” bar code
below and finally, exit programming mode by scanning
the “END” barcode below
DEFAULT SETTING FOR THIS FEATURE:
00 (No Delay)
Set
Intercharacter
Delay
SET
END

Datalogic QuickScan QS6500 Specifications

General

Scan speed	450 sec/page
Tilt angle range	-60 - 60 °
Maximum scan area	610 mm
Decoding standards	- 1D - Code 16K - EAN/JAN - GS1 DataBar - PDF Models - GS1 DataBar Expanded Stacked - GS1 DataBar Stacked - GS1 DataBar Stacked Omnidirectional - MicroPDF417 - PDF417 - UPC A/E
Dimensions (WxDxH)	165 x 74 x 99 mm
Cable length	2.44 m
Standard interfaces	Keyboard wedge
Input voltage	4.5 - 14 V
Power consumption	300 mA
Certification	RoHS
Product color	Black
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	0 - 50 °C
Operating relative humidity (H-H)	5 - 95 %

Weight and Dimensions

Weight	181.4 g