DATAVS2-VSM INSTRUCTION MANUAL
Restart the device to apply correctly the changes.
To return to main panel without saving, press ESC.
8.2 SENSOR SETTINGS
This panel, when a DataVS2 is connected, can display information such as name, firmware,
Hardware revision, MAC and modify the sensor network parameters: IP, Netmask and
DHCP...
To change the network parameters of DataVS2, the user has to simply move the focus on
the desired value and use the UP/DOWN ARROWS to increase or decrease the current
value.
To save the changes press SET.
Restart DataVS2 to apply correctly the changes.
To return to main panel without saving, press ESC.
DataVS2 Info
unchangeable
To Next Page
Loading...
