Datalogic VS Series User Manual

DATAVS2-VSM INSTRUCTION MANUAL
28
8
8.3.6 Cancellation of a DataVS2 Slot
Just like the VSM slots, the desired slot has to be selected (refer to previous paragraph
“Selection of slot (DataVS2)”). Obviously the monitor must be connected to a sensor to
access its memory.
Then move the focus on “Delete Current” button (on the bottom right side of the screen)
and press SET to confirm:
Another operation confirmation is requested also for the DataVS2 slots:
To proceed press ARROW UP otherwise, press ARROW DOWN to abandon. In both cases,
the information label will display the operation result and a refresh of the panel names will be
made.
NOTA
It is not possibile to delete actual running inspection.
8.3.7 Cancellation of all the VSM Slots
To cancel all the VSM memory slots no specific slot has to be selected but the user must
only move the focus on the “Delete ALL” icon on the bottom left side of the screen and
press SET.
Confirm

Datalogic VS Series Specifications

General

Brand	Datalogic
Model	VS Series
Category	Controller
Language	English