Datalogic VS Series User Manual

DATAVS2-VSM INSTRUCTION MANUAL
26
8
8.3.2 Slot Selection (DataVS2)
The slot selection is similar to the VSM one: the focus must be moved using the ARROWS
on the “SENSOR” label and SET must be pressed. The focus will be moved inside the
memory list and once chosen the desired one press SET to confirm.
Once selected both memory slots, the transfer operations can be made.
8.3.3 Transfer from VSM to DataVS2
To transfer the memory slot from VSM to DataVS2 (after selecting both the source as well as
the destination) move the focus on the “Arrow on Right” button and press SET.
At this point the information label will request another operation confirmation, to proceed
press ARROW UP, otherwise press ARROW DOWN to abandon.
If confermed, the data will be transferred between VSM and DataVS2. As soon as the
operation has finished, an information label will display the result and a refresh of the panel
names will be made.

Datalogic VS Series Specifications

General

Brand	Datalogic
Model	VS Series
Category	Controller
Language	English