Dell EMC PowerEdge R540 - Installing an Expansion Card Riser

Figure 79. Removing buttery riser
Next step
Install the expansion card riser.
Related link
Installing an expansion card riser
Installing an expansion card riser
Prerequisite
1 Follow the safety guidelines listed in Safety instructions.
Steps
1 If removed, install the expansion cards into the expansion card riser.
2 Holding the touch points, align the expansion card riser with the connector and the riser guide pin on the system board.
3 Lower the expansion card riser into place until the expansion card riser connector is fully seated in the connector.
Installing and removing system components
125