Figure 112. Removing power interposer board
Next step
1 Install the power interposer board.
Related link
Removing the air shroud
Removing a power supply unit
Installing power interposer board
Installing power interposer board
Prerequisite
Follow the safety guidelines listed in Safety instructions.
Steps
1 Align the slots on the PIB with the hook on the PSU cage and slide it into place.
2 Using Phillips #2 screwdriver, tighten the screw to secure the PIB to the system.
3 Route the cables and connect it to the system board.
158
Installing and removing system components
To Next Page
Loading...
