Figure 35. Installing internal PERC riser
Next steps
1 Close the cable guiding latch.
2 Install the air shroud.
3 Follow the procedure listed in After working inside your system.
Related link
Installing the air shroud
Removing PERC card from internal PERC riser
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your system.
3 Remove the internal PERC riser.
Steps
1 Using Phillips #2 screwdriver, remove the screw that secures the PERC card to the internal PERC riser.
2 Pull the PERC card out of the connector on the internal PERC riser.
82
Installing and removing system components
To Next Page
Loading...
