Figure 110. Removing non-redundant cabled AC PSU
Next step
1 Installing a non-redundant cabled AC power supply.
Related link
Removing the air shroud
Removing an expansion card riser
Installing a non-redundant cabled AC power supply unit
Installing a non-redundant cabled AC power supply unit
Prerequisite
1 Follow the safety guidelines listed in Safety instructions.
Steps
1 Unpack the new power supply unit (PSU).
2 Slide the new PSU into the PSU cage until the PSU is fully seated.
3 Using Phillips #2 screwdriver, tighten the screw to secure the PSU to the system.
Installing and removing system components
153
To Next Page
Loading...
