Dell EMC PowerEdge R540 - Installing Internal PERC Riser

Next step
1 Install the internal PERC riser.
Related link
Removing the air shroud
Installing internal PERC riser
Installing internal PERC riser
Prerequisite
1 Follow the safety guidelines listed in Safety instructions.
Steps
1 Connect the cable to the internal PERC riser.
Figure 34. Connecting the cable to internal PERC riser
2 Holding the blue touch points, align the slot on the internal PERC riser to the guide on the system board.
3 Press until the internal PERC riser clicks into place.
4 Close the plunger.
Installing and removing system components
81