1. Lift the mylar and use your fingertips to carefully spread apart the securing-clips on each end of the memory-module slot until the
memory module pops up.
2. Slide and remove the memory module off the memory module slot on the system board.
Installing the memory modules
If you are replacing a component, remove the existing component before performing the installation procedure.
The figure indicates the location of the memory module and provides a visual representation of the installation procedure.
1. Lift the mylar and align the notch on the memory module with the tab on the memory-module slot.
2. Slide the memory module firmly into the slot at an angle.
Removing and installing components
17
To Next Page
Loading...
