1. Place the heat sink on the system board and align the screw holes on the heat sink with the screw holes on the system board.
2. In sequential order (as indicated on the heat sink), tighten the seven captive screws that secure the heat sink to the system board.
1. Install the CPU fan.
2. Install the GPU fan.
3. Install the battery.
4. Install the base cover.
5. Follow the procedure in After working inside your computer.
Coin-cell battery
Removing the coin-cell battery
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the battery.
NOTE:
Removing the coin-cell battery resets the BIOS setup program's settings to default. It is recommended that you
note the BIOS setup program's settings before removing the coin-cell battery.
The figure indicates the location of the coin-cell battery and provides a visual representation of the removal procedure.
Removing and installing components
35
To Next Page
Loading...
