Power button with optional fingerprint reader
Removing the power button and optional fingerprint
reader
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the battery.
4. Remove the WLAN card.
5. Remove the GPU fan.
6. Remove the I/O board.
The figure indicates the location of the power button with optional fingerprint reader and provides a visual representation of the removal
procedure.
1. Remove the two screws (M1.2x2) that secure the power button with optional fingerprint reader to the palm-rest and keyboard
assembly.
2. Lift the power button with optional fingerprint-reader, along with the fingerprint reader cable, off the palm-rest and keyboard
assembly.
Installing the power button with optional fingerprint
reader
If you are replacing a component, remove the existing component before performing the installation procedure.
The figure indicates the location of the power button with fingerprint reader and provides a visual representation of the installation
procedure.
40
Removing and installing components
To Next Page
Loading...
