1. Remove the screw (M2x4) that secures the solid-state drive to the system board.
2. Slide and remove the solid-state drive module from the solid-state drive slot on the system board.
Installing the M.2 2280 PCIe solid-state drive
If you are replacing a component, remove the existing component before performing the installation procedure.
The figure indicates the location of the M.2 2280 PCIe solid-state drive and provides a visual representation of the installation procedure:
1. Align the notch on the solid-state drive module with the tab on the solid-state drive slot.
2. Slide the solid-state drive module firmly into the solid-state drive slot at an angle.
3. Replace the screw (M2x4) that secures the solid-state drive module to the system board.
24
Removing and installing components
To Next Page
Loading...
