1. Place the hard drive into the hard-drive bracket.
2. Align the screw holes on the hard-drive bracket with the screw holes on the hard drive, and then replace the four screws (M3x3) that
secure the hard-drive bracket to the hard drive.
3. Connect the interposer to the hard-drive assembly.
4. Align the screw holes on the hard-drive assembly with the screw holes on the palm-rest and keyboard assembly.
5. Replace the three screws (M2x4) that secure the hard-drive assembly to the palm-rest and keyboard assembly.
6. Connect the hard-drive cable to the system board.
1. Connect the battery cable.
2. Install the base cover.
3. Follow the procedure in After working inside your computer.
Speakers
Removing the speakers
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the battery.
The figure indicates the location of the speakers and provides a visual representation of the removal procedure.
Removing and installing components
27
To Next Page
Loading...
