1. In sequential order (as indicated on the heat sink), loosen the four captive screws that secure the heat sink to the system board.
2. Lift and remove the heat sink off the palm-rest and keyboard assembly.
Installing the heat sink—UMA
If you are replacing a component, remove the existing component before performing the installation procedure.
The figure indicates the location of the heat sink and provides a visual representation of the installation procedure.
1. Place the heat sink on the system board and align the screw holes on the heat sink with the screw holes on the system board.
2. In sequential order (as indicated on the heat sink), tighten the four captive screws that secure the heat sink to the system board.
1. Install the CPU fan.
Removing and installing components
33
To Next Page
Loading...
