1. Slide the ports on the system board into the slots on the palm-rest and keyboard assembly and align the screw holes on the system
board with the screw holes on the palm-rest and keyboard assembly.
2. Replace the six screws (M2x4) that secure the system board to the palm-rest and keyboard assembly.
3. Connect the display cable on to the connector on the system board.
4. Adhere the tape that secures the display cable to the system board.
5. Replace the two screws (M2x5) that secure the USB Type-C port bracket to the system board.
6. Connect the keyboard-backlight cable to the system board and close the latch to secure the cable.
7. Connect the touchpad cable to the system board and close the latch to secure the cable.
8. Connect the speaker cable to the system board.
9. Connect the power-adapter cable to the system board.
10. Connect the I/O-board cable to the system board and close the latch to secure the cable.
1. Install the display assembly.
2. Install the memory module.
3. Install the heat sink.
4. Install the left-side fan.
5. Install the right-side fan.
6. Install the WLAN card.
7. Install the M.2 2230 solid-state drive.
8. Install the M.2 2280 solid-state drive.
9. Install the battery.
10. Install the base cover.
11. Follow the procedure in After working inside your computer.
Removing and installing components
57
To Next Page
Loading...
