1204 Managing IPv4 and IPv6 Multicast
Configuring and Viewing PIM-DM for IPv6 Multicast Routing
Beginning in Privileged EXEC mode, use the following commands to
configure PIM-DM for IPv6 multicast routing on the switch and on VLAN
routing interfaces and to view PIM-DM information.
Command Purpose
configure Enter global configuration mode.
ipv6 pim dense Enable PIM-DM on the switch.
interface vlan
vlan-id
Enter Interface Configuration mode for the
specified VLAN.
ipv6 pimdm Enable PIM-DM on the interface.
ipv6 pimdm hello-interval
seconds
Specify the number of seconds (range: 0–65535)
to wait between sending PIM hello messages on
the interface.
exit Exit to Privileged EXEC mode.
show ipv6 pim View system-wide PIM-DM information.
show ipv6 pimdm interface vlan
vlan-id
View the PIM-DM information for the specified
interface.
show ipv6 pimdm neighbor
[interface vlan
vlan-id
| all]
View a summary or all the details of the multicast
table.
To Next Page
Loading...
