Dell PowerConnect 7048P - Configuring HTTP and HTTPS Access

Controlling Management Access 223
Configuring HTTP and HTTPS Access
Beginning in Privileged EXEC mode, use the following commands to specify
HTTP and HTTPS server settings on the switch.
show crypto key pubkey-
chain ssh [username
username ] [fingerprint
bubble-babble|hex]
View SSH public keys stored on the switch.
• username — Specifies the remote SSH client username.
(Range: 1–48 characters)
•
bubble-babble — Fingerprints in Bubble Babble format.
•
hex — Fingerprint in Hex format. If fingerprint is
unspecified, it defaults to Hex format.
show crypto key
mypubkey [rsa|dsa]
View the SSH public keys of the switch.
Command Purpose
configure Enter Global Configuration mode.
ip http server Enable HTTP access to the switch (enabled by default).
crypto certificate
number generate
Generate a self-signed HTTPS certificate and enter into
Crypto Certificate Generation mode.
• number — Specifies the certificate number. (Range: 1–2)
common-name name Specifies the common name.
country
name Specifies the country name.
duration
days Specifies number of days a self-signed certification would
be valid. If unspecified defaults to 365 day.
email email_address Specifies the contact email address.
key-generate
length Specify the length of the SSL's RSA key. If unspecified,
length defaults to 1024.
location name Specifies the location or city name.
organization-name
name
Specifies the organization name
organization-unit name Specifies the organization internal unit
state
name Specifies the state or province name.
Command Purpose