158 Managing a Switch Stack
Basic Failover
In this example, the stack has four members that are connected through a
daisy-chain, as Figure 8-11 shows.
Figure 8-11. Basic Stack Failover
When all four units are up and running, the show switch CLI command gives
the following output:
console#show switch
SW Management
Status
Standby
Status
Preconfig
Model ID
Plugged-
in Model
ID
Switch
Status
Code
Version
--- --------- ------- -------- --------- -------
---
--------
1 Stack Member PCT7048 PCT7048 OK 9.19.0.2
2 Stack Member PCT7048 PCT7048 OK 9.19.0.2
3 Mgmt Switch PCT7048 PCT7048 OK 9.19.0.2
4 Stack Member PCT7048 PCT7048 OK 9.19.0.2
To Next Page
Loading...
