Dell PowerConnect 7048P - Configuring Acls (Web); IP ACL Configuration

Configuring Access Control Lists 545
Configuring ACLs (Web)
This section provides information about the OpenManage Switch
Administrator pages for configuring and monitoring ACLs on a
PowerConnect 7000 Series switch. For details about the fields on a page, click
at the top of the page.
IP ACL Configuration
Use the IP ACL Configuration page to add or remove IP-based ACLs.
To display the IP ACL Configuration page, click Switching
→ Network
Security
→ Access Control Lists → IP Access Control Lists →
Configuration in the navigation panel.
Figure 20-1. IP ACL Configuration
Adding an IPv4 ACL
To add an IPv4 ACL:
1
Open the IP ACL Configuration page.
2 Click Add to display the Add IP ACL page.
3 Specify an ACL name.