Dell PowerConnect 7048P - Configuring a Port in Access Mode

Configuring VLANs 603
Configuring a Port in Access Mode
Beginning in Privileged EXEC mode, use the following commands to
configure an untagged layer 2 VLAN interface and assign the interface to a
VLAN. When a port is in access mode, it can only be a member of one
untagged VLAN. When you configure the interface as a VLAN member, the
interface is automatically removed from its previous VLAN membership. You
can configure each interface separately, or you can configure a range of
interfaces with the same settings.
Command Purpose
configure Enter global configuration mode.
interface interface Enter interface configuration mode for the specified
interface. The
interface variable includes the interface type
and number, for example gigabitethernet 1/0/3.
You can also specify a range of interfaces with the interface
range command, for example, interface range
gigabitethernet 1/0/8-12 configures interfaces 8, 9, 10, 11,
and 12.
switchport mode access Configure the interface as an untagged layer 2 VLAN
interface.
switchport access vlan
vlan-id
Configure the interface as a member of the specified
VLAN.
vlan-id — A valid VLAN ID of the VLAN to which the port
is configured. (Range: 1–4093)
CTRL + Z Exit to Privileged EXEC mode.
show interfaces
switchport interface
Display information about the VLAN settings configured
for the specified interface.