Controlling Management Access 221
Configuring TACACS+ Server Information
Beginning in Privileged EXEC mode, use the following commands to specify
TACACS+ server settings on the switch.
show radius statistics
[[accounting |
authentication]
{
ipaddress
|
hostname
|
name
servername
}]
View the RADIUS statistics for the switch. You can specify
additional information to narrow the scope of the
command output.
•
accounting
|
authentication
— The type of server
(accounting or authentication).
•
ipaddress
— The RADIUS server host IP address.
•
hostname
— Host name of the Radius server host
(Range: 1–158 characters).
•
servername
— The alias used to identify the server.
Command Purpose
configure Enter Global Configuration mode.
tacacs-server host {
ip-
address
|
hostname
}
Configure a TACACS+ server and enter into the
TACACS+ configuration mode.
key [
key-string
] Set the authentication and encryption key for all
TACACS+ communications between the switch and the
TACACS+ server.
NOTE: You can also use the tacacs-server key [
key-string
]
command in Global Configuration mode to set the same
authentication and encryption key for all configured
TACACS+ servers.
priority
priority
Specify the order in which the servers are to be used, with
0 being the highest priority. The range is 0-65535, with 0
being the highest priority.
<CTRL + Z> Exit to Privileged EXEC mode.
show tacacs [
ip-address
] View the configuration and statistics of all configured
TACACS+ servers or a specific server.
Command Purpose
To Next Page
Loading...
