Dell PowerConnect 7048P - Page 620

620 Configuring VLANs
a. From the Switching → VLAN → LAG Settings page, make sure Po1
is selected.
b. Configure the following settings:
• Port VLAN Mode — General
•PVID — 400
• Frame Type — AdmitAll
c. Click Apply .
Figure 21-28. LAG Settings
6 Configure port 1 as a trunk port.
a From the Switching → VLAN → Port Settings page, make sure port
Gi1/0/1 i s selected.
b From the Port VLAN Mode field, select Trunk.
c Click Apply .