Dell PowerConnect 7048P - Page 978

978 Configuring OSPF and OSPFv3
Configuring OSPF Route Redistribution Settings
Beginning in Privileged EXEC mode, use the following commands to
configure OSPF route redistribution settings.
Command Purpose
configure Enter global configuration mode.
router ospf Enter OSPF configuration mode.
distribute-list
accesslistname out {rip |
static | connected}
Specify the access list to filter routes received from the
source protocol. The ACL must already exist on the
switch. For information about the commands you use to
configure ACLs, see "Configuring ACLs (CLI)" on
page 558.
• accesslistname — The name used to identify an existing
ACL.
•
rip — Apply the specified access list when RIP is the
source protocol.
• static — Apply the specified access list when packets
come through the static route.
•
connected — Apply the specified access list when
packets come from a directly connected route.
redistribute {rip | static |
connected} [metric
integer ] [metric-type {1 |
2}] [tag
integer ] [subnets]
Configure OSPF to allow redistribution of routes from
the specified source protocol/routers.
• rip — Specifies RIP as the source protocol.
•
static — Specifies that the source is a static route.
•
connected — Specifies that the source is a directly
connected route.
•
metric — Specifies the metric to use when
redistributing the route. (Range: 0–16777214)
•
metric-type 1 — Type 1 external route.
•
metric-type 2 — Type 2 external route.
•
tag — Value attached to each external route. (Range:
0–4294967295)
•
subnets —Unless this keyword is configured, OSPF
distributes only class A, class B, and class C prefixes.