2. Follow the procedure listed in the Before working inside your system section.
3. Remove the cooling shroud.
4. Keep the Phillips #2 screwdriver ready.
1. Loosen the screws that secure the integrated storage controller cable to the integrated storage controller card connector on
the system board.
2. Lift the integrated storage controller cable away from the integrated storage controller.
3. Lift one end of the card and angle it to disengage the card from the integrated storage controller card holder on the system
board.
4. Lift the card out of the system.
Figure 56. Removing the integrated storage controller card
1.
integrated storage controller cable 2. integrated storage controller card
3. integrated storage controller card connector on the
system board
4. integrated storage controller card holder
1. Install the cooling shroud.
2. Installing the integrated storage controller card.
3. Follow the procedure listed in the After working inside your system section.
Related references
Safety instructions
Related tasks
Before working inside your system
Removing the cooling shroud
Removing expansion card risers
Installing expansion card risers
Installing the cooling shroud
After working inside your system
Installing the integrated storage controller card
Installing and removing system components
107
To Next Page
Loading...
