Installing the VGA module
CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that are shipped with your product.
NOTE: This procedure applies only to the eight hard drive system.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Keep the Philips #2 screwdriver ready.
1. Push the VGA module into the chassis and align the threaded screw hole on the VGA module with the screw hole on the
chassis.
2. Replace the screw (at the bottom of the chassis) that secures the VGA module to the chassis.
3. Replace the control panel.
4. Connect the VGA module cable to the VGA module.
CAUTION: The display module connector is a ZIF (zero insertion force) connector. Ensure that the locking
tab on the connector is released before removal and insertion. The locking tab must be engaged after
insertion.
5. Connect the display module cables to the control panel board.
Figure 94. Installing the VGA module
1.
screw 2. VGA module cable
3. VGA module 4. control panel
Follow the procedure listed in the After working inside your system section.
Related references
Safety instructions
Related tasks
Installing the control panel–10 hard drive system and 24 hard drive system
Installing the control panel–eight hard drive system
Installing and removing system components
145
To Next Page
Loading...
