Dell PowerEdge R630 - Initializing the TPM for Bitlocker Users; Initializing the TPM for TXT Users

1. Install the system board.
2. Follow the procedure listed in the After working inside your system section.
Related references
Safety instructions
System board jumpers and connectors
Related tasks
Before working inside your system
Installing the system board
Initializing the TPM for BitLocker users
Initialize the TPM.
For more information about initializing the TPM, see https://technet.microsoft.com/en-us/library/cc753140.aspx.
The TPM Status changes to Enabled, Activated.
Initializing the TPM for TXT users
1. While booting your system, press F2 to enter System Setup.
2. On the System Setup Main Menu screen, click System BIOS > System Security Settings.
3. From the TPM Security option, select On with Pre-boot Measurements.
4. From the TPM Command option, select Activate.
5. Save the settings.
6. Restart your system.
7. Enter System Setup again.
8. On the System Setup Main Menu screen, click System BIOS > System Security Settings.
9. From the Intel TXT option, select On.
152
Installing and removing system components