Table 5. Back panel features (two PCIe expansion cards)
Item Indicator, Button, or
Connector
Icon Description
1 System identification button The identification buttons on the front and back panels can
be used to locate a particular system within a rack. When one
of these buttons is pressed, the LCD panel on the front and
the system status indicator on the back flash until one of the
buttons is pressed again.
Press to toggle the system ID on and off. If the system stops
responding during POST, press and hold the system ID button
for more than five seconds to enter BIOS progress mode.
To reset iDRAC (if not disabled in F2 iDRAC setup), press and
hold for more than 15 seconds.
2 System identification
connector
Enables you to connect the optional system status indicator
assembly through the optional cable management arm.
3 iDRAC8 Enterprise port Dedicated management port.
NOTE: The port is available for use only if the iDRAC8
Enterprise license is installed on your system.
4 PCIe expansion card slot (riser
1)
Enables you to connect a low profile PCIe expansion card. See
the Expansion card installation guidelines section.
5 Serial connector Enables you to connect a serial device to the system.
6 Video connector Enables you to connect a VGA display to the system.
7 USB ports (2) Enables you to connect USB devices to the system. The ports
are USB 3.0-compliant.
8 PCIe expansion card slot (riser
2)
Enables you to connect a full height three-fourth length PCIe
expansion card. See the Expansion card installation guidelines
section.
9 Ethernet connectors (4) Four integrated 10/100/1000 Mbps NIC connectors
or
Four integrated connectors:
● Two integrated 10/100/1000 Mbps NIC connectors
● Two integrated 100 Mbps/1 Gbps/10 Gbps SFP+
connectors
or
● Four 10 Gbps
10 PSU1
● Two 495 W, 750 W, or 1100 W AC power supply units
(PSUs)
Or
● Two 1100 W DC PSUs
Or
● Two 750 W mixed mode PSUs
11 PSU2
● Two 495 W, 750 W, or 1100 W AC PSUs
Or
● Two 1100 W DC PSUs
Or
● Two 750 W mixed mode PSUs
Dell PowerEdge R630 system overview 17