Figure 78. Installing the OCP card
Next steps
1. Replace the expansion risers.
2. Follow the procedure listed in After working inside your system.
LOM card and rear I/O board
Installing the LOM card and rear I/O board
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
3. Remove the air shroud.
4. Remove the expansion card risers.
Steps
1. Align the connectors and slots on the LOM card or rear I/O board with the connector and standoffs on the system board.
2. Press the LOM card or rear I/O board until firmly seated on the system board connector.
3. Using a Phillips 2 screwdriver, secure the LOM card or rear I/O board to the system board with screws.
Installing and removing system components
109
To Next Page
Loading...
