Dell PowerEdge XE8640 - Optional BOSS-N1 Module

Next steps
1. Replace the LOM card and rear I/O board.
Optional BOSS-N1 module
Removing the BOSS-N1 module blank
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
Steps
Use a screwdriver to push out the blank from the BOSS-N1 module bay.
Figure 83. Removing the BOSS-N1 module blank
Next steps
Replace the BOSS-N1 module blank or install BOSS-N1 module
Installing the BOSS-N1 module blank
Prerequisites
Follow the safety guidelines listed in the Safety instructions
Steps
Align the blank with the BOSS-N1 module bay and push it into the bay until it clicks into place.
112
Installing and removing system components