Figure 40. Removing the cooling fan cage assembly
Next steps
1. Replace the cooling fan cage assembly.
Installing the cooling fan cage assembly
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
CAUTION:
Ensure that the cables inside the system are correctly installed and retained by the cable
retention bracket before installing the cooling fan cage assembly. Incorrectly installed cables may get
damaged.
2. Follow the procedure listed in the Before working inside your system.
3. Remove the air shroud.
4. Remove front top cover
5. Remove the cooling fan
6. Observe and disconnect the cables from system board and backplane.
Steps
1. Holding the blue release plunger of the cooling fan cage, align the guide rails with the guides on the system.
2. Lower the cooling fan cage assembly into the system until seated firmly.
3. Flip in the blue release plunger to lock the cooling fan cage assembly into the system.
80
Installing and removing system components
To Next Page
Loading...
