Steps
1. Align and slide the left control panel in the slot on the system.
2. Route the left control panel cable through the side wall of the system.
3. Align and slide the left control panel cable cover in the slot on the system.
NOTE: Route the cable properly to prevent the cable from being pinched or crimped.
4. Connect the left control panel cable to the connector on the system board .
5. Using the Phillips 1 screwdriver, tighten the screws to secure the left control panel and the cable cover to the system.
Figure 104. Installing the left control panel
Next steps
1. Replace the cooling fan cage assembly and fans.
2. Replace the air shroud
3. Replace the front top cover.
4. Follow the procedure listed in After working inside your system.
Versabay board (VSB)
Removing the VSB
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
3. Remove the air shroud
4. Remove the expansion card risers.
Steps
1. Remove the screws to disengage the VSB cable from the VSB board connected to the system board.
2. Disconnect the signal cable from the VSB.
128
Installing and removing system components
To Next Page
Loading...
