Installing the right control panel
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
3. Remove the front top cover.
4. Remove the air shroud.
5. Remove the cooling fan and fan cage assembly.
Steps
1. Align and slide the right control panel into the slot on the system.
2. Route the right control panel cable through the side wall of the system.
3. Align and slide the right control panel cable cover in the slot on the system.
NOTE: Route the cable properly to prevent the cable from being pinched or crimped.
4. Connect the right control panel cable and VGA cable to the connectors on the system board.
5. Using the Phillips 1 screwdriver, tighten the screws that secure the right control panel and the cable cover to the system.
Figure 102. Installing the right control panel
Next steps
1. Replace the cooling fan cage assembly and fans.
2. Replace the air shroud
3. Replace the front top cover.
4. Follow the procedure listed in After working inside your system.
126
Installing and removing system components
To Next Page
Loading...
