Installing the BOSS-N1 card, M.2 SSD module, BOSS-N1 card
carrier
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
3. Remove the air shroud.
Steps
1. Align the BOSS-N1 module at an angle with the controller card module slot.
2. Insert the BOSS-N1 module and push the module horizontally toward the rear of the system until firmly seated.
3. Using the Phillips 1 screwdriver, secure the BOSS-N1 module with the M3 x 0.5 x 4.5 mm screw.
Figure 91. Installing the BOSS-N1 module
4. Connect the BOSS-N1 power and signal cables to the connectors on the BOSS-N1 module.
Installing and removing system components
117
To Next Page
Loading...
