System board tray
Removing the system board tray
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
3. Remove the air shroud.
4. Remove the front top cover.
5. Remove the cooling fan and fan cage assembly.
6. Remove the expansion card risers.
7. Remove the memory modules.
8. Remove the heat sink.
9. Remove the processors.
10. Remove the OCP card (if installed).
11. Remove the power supply units (PSU).
12. Remove the VSB
13. Disconnect cables that are connected to the components.
14. Remove the system board
Steps
1. Unlock the blue release plunger to unlock the system board tray from the chassis
2. Hold the blue release plunger, and lift the system board tray away from the chassis.
Figure 111. Removing the system board tray
Next steps
1. Replace the system board tray.
Installing and removing system components
135
To Next Page
Loading...
