Figure 114. Removing the LAAC assembly
Next steps
Replace the GPU assembly.
Installing the LAAC GPU Dip tray
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
3. Remove the air shroud.
4. Remove the front top cover.
5. Remove the cooling fan and fan cage assembly.
6. Remove the expansion card risers.
7. Remove the memory modules.
8. Remove the heat sink.
9. Remove the processors.
10. Remove the OCP card (if installed).
11. Remove the power supply units (PSU).
12. Remove the VSB
13. Disconnect cables that are connected to the components.
14. Remove the system board
15. Remove the system board tray.
Steps
1. Push down the black latch and reconnect the GPU cable connecting on the NVlink baseboard.
2. Hold the two blue thumb screws and rotate the GPU assembly toward front of the system.
3. Using a Phillips 2 screwdriver, tighten the two blue thumb screws on both side of the GPU assembly.
138
Installing and removing system components
To Next Page
Loading...
