Installing the VSB
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
3. Remove the air shroud.
4. Remove the expansion card risers.
Steps
1. Align the VSB on the tray and tighten the screws to secure the VSB on to the VSB tray.
Figure 107. Installing the VSB on to VSB tray
2. Lift the plunge, align the VSB tray to the system board and slide it toward the front of the system.
3. Connect the signal cable on the VSB.
4. Align the power cable to the VSB and secure the cables with the screws.
NOTE: The procedure to install the left and right VSBs are same.
130 Installing and removing system components
To Next Page
Loading...
