Next steps
Replace the power distribution board (PDB).
Installing the power distribution board
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system .
3. Remove all the components that are listed in the removing the power distribution board section.
Steps
1. Using the PDB holders, align the PDB tray to the guiding pins in the chassis. Lower it and slide to the rear of the system.
2. Lock the plungers on the PDB tray to secure it to the chassis.
Figure 118. Installing the PDB tray
Next steps
1. Install the following components:
a. LAAC.
b. System board tray.
c. System board.
d. Power supply units (PSU).
e. OCP card (if installed).
f. Processor.
g. Heat sink.
h. Memory modules.
i. Cooling fan cage assembly and cooling fan.
j. Air shroud.
k. Front top cover.
2. Connect any cables which were previously disconnected from the components.
3. Follow the procedure listed in After working inside your system.
Installing and removing system components
141
To Next Page
Loading...
