Figure 94. Installing the BOSS-N1 card carrier
Next steps
1. Follow the procedure listed in After working inside your system.
Removing the BOSS-N1 cage
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
3. Remove the expansion card riser 4A.
Steps
1. Using a Phillips 2 screwdriver, loosen the two blue thumb screws that secures the BOSS-N1 cage to the system.
2. Lift the BOSS-N1 cage away from the system.
Installing and removing system components
119
To Next Page
Loading...
