3. Disconnect the power cable and keep it away from the system.
4. Lift the plunger and slide the VSB tray to rear of the system.
5. Disengage the VSB tray from the system board and lift it out of the system.
NOTE: The procedure to remove the left and right VSB is similar.
Figure 105. Removing the VSB with the tray
6. Remove all the screws and lift the VSB from the VSB tray.
Figure 106. Removing the VSB from VSB tray
Next steps
Replace the Versabay assembly.
Installing and removing system components
129
To Next Page
Loading...
