Table 33. Processor Settings details (continued)
Option Description
The feature supports operating system recovery for cases of
multiple recoverable faults that are detected close, which would
otherwise result in a fatal machine check event. The feature is
available only on Advanced RAS processors. This option is set to
Enabled by default.
CPU Crash Log Support This field controls Intel CPU Crash Log feature for collection
of previous crash data from shared SRAM of Out-of -Band
Management Service Module at post reset. This option is set
to Disabled by default.
Processor n
NOTE: Depending on the number of processors, there might
be up to n processors listed.
The following settings are displayed for each processor:
Table 34. Processor n details
Option Description
Family-Model-Stepping Specifies the family, model, and stepping of the processor as
defined by Intel.
Brand Specifies the brand name.
Level 2 Cache Specifies the total L2 cache.
Level 3 Cache Specifies the total L3 cache.
Number of Cores Specifies the number of cores per processor.
Microcode Specifies the processor microcode version.
SATA Settings
To view the SATA Settings screen, power on the system, press F2, and click System Setup Main Menu > System BIOS >
SATA Settings.
Table 35. SATA Settings details
Option Description
Embedded SATA Enables the embedded SATA option to be set to Off, AHCI mode , or RAID modes.
This option is set to AHCI Mode by default.
NOTE:
1. You might also need to change the Boot Mode setting to UEFI. Otherwise, you
should set the field to Non-RAID mode.
2. No ESXi and Ubuntu OS support under RAID mode.
Security Freeze Lock Sends Security Freeze Lock command to the embedded SATA drives during POST.
This option is applicable only for AHCI Mode. This option is set to Enabled by default.
Write Cache Enables or disables the command for the embedded SATA drives during POST. This
option is applicable only for AHCI Mode. This option is set to Disabled by default.
NVMe Settings
This option sets the NVMe drive mode. If the system contains NVMe drives that you want to configure in a RAID array, you
must set both this field and the Embedded SATA field on the SATA settings menu to RAID Mode. You may also need to change
the Boot Mode setting to UEFI.
Pre-operating system management applications
39
To Next Page
Loading...
