Dell PowerEdge XE8640 - Page 56

Table 55. Configuration validation error (continued)
Error Description Possible cause and
recommendations
Example
Missing element or cable
is reported in HWC8010
error logs. Install the
missing element (cable,
risers, etc).
Config Missing : SL cable
PLANAR_SL8 and CTRL_DST_PA1
Comm Error A configuration element is not responding
to iDRAC using the management interface
while running an inventory check.
System management
sideband communication
Comm Error: Backplane 2
Unplug AC Power, reseat
the element and replace
the element if the problem
persists.
56 Minimum to POST and system management configuration validation