Steps
For Riser 1A and Riser 4A, holding the blue touch points, align the holes on the expansion card riser with the guides on the
system board. Lower the expansion card riser into place and press the touch points until the expansion card riser connector is
fully seated on the system board connector. Using a Phillips 2 screwdriver, tighten the blue thumb screw on the riser.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 61. Installing the expansion card riser (Riser 1A)
Figure 62. Installing the expansion card riser (Riser 4A)
Next steps
1. If required, connect the cables to the expansion card or the risers.
2. Follow the procedure listed in After working inside your system.
3. Install any device drivers required for the card as described in the documentation for the card.
98
Installing and removing system components
To Next Page
Loading...
