Dell PowerEdge XR4510c

Figure 25. Installing the BOSS-N1 card
Next steps
After working inside your system.
Removing the M.2 SSD module
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedure listed in Before working inside your system.
3. Remove the BOSS-N1 card.
Steps
1. Using the Phillips 1 screwdriver, remove the screw that secures the M.2 SSD module to the BOSS-N1 card.
2. Pull the M.2 SSD module to disconnect from the connector on the BOSS-N1 card.
Figure 26. Removing the M.2 SSD module
Next steps
If applicable, Install the BOSS-N1 card.
62
Installing and removing system components