Delta AH500 - Page 574

AH500 Programming Manual
6-406
The PLC receives the data.
Data
Description
‘0’
16#30
ADR 1
‘1’
16#31
ADR 0
‘0’
16#30
CMD 1
‘3’
16#33
CMD 0
‘0’
16#30
Number of data (counted by the byte)
‘A’
16#41
‘0’
16#30
Data in the device at
address 16#2100
The PLC automatically converts the ASCII
character into the value 16#0000, and 16#0000
is stored in D100.
‘0’
16#30
‘0’
16#30
‘0’
16#30
‘0’
16#30
Data in the device at
address 16#2101
The PLC automatically converts the ASCII
character into the value 16#0500, and 16#0500
is stored in D101.
‘5’
16#35
‘0’
16#30
‘0’
16#30
‘0’
16#33
Data in the device at
address 16#2102
The PLC automatically converts the ASCII
character into the value 16#01F4, and 16#01F4
is stored in D1072.
‘1’
16#45
‘F’
16#30
‘4’
16#30
‘0’
16#30
Data in the device at
address 16#2103
The PLC automatically converts the ASCII
character into the value 16#0000, and 16#0000
is stored in D1073.
‘0’
16#30
‘0’
16#30
‘0’
16#30
‘0’
16#30
Data in the device at
address 16#2104
The PLC automatically converts the ASCII
character into the value 16#0000, and 16#0000
is stored in D1074.
‘0’
16#30
‘0’
16#30
‘0’
16#30
‘2’
16#32
LRC CHK 1
‘A’
16#41
LRC CHK 0
Additional remark:
1. Please refer to the additional remark on the instruction RS for more information about the
related flags and the special registers.
2. The instructions FWD, REV, STOP, RDST, and RSTEF can be used several times in the
program, but one instruction is executed at a time.
3. If the value in S exceeds the range, the instruction is not executed, SM0 is ON, and the error
code in SR0 is 16#2003.
4. If D+4 exceeds the device range, the instruction is not executed, SM0 is ON, and the error
code in SR0 is 16#2003.
5. If users declare the operand D in ISPSoft, the data type will be ARRAY [5] of WORD/INT.