Chapter 2 Devices
2-45
Refresh time
AH5×1
SM1596 is ON when the COM1-Modbus connection is enabled
and an error occurs.
Users set the flag to ON and reset it to OFF.
Users set the flag to ON and reset it to OFF.
SM1769
SM1769 is ON when there is an error in the Ether Link.
The flag is refreshed every scan cycle.
SM1770
Users set the flag ON and reset it OFF.
The flag is refreshed every scan cycle.
Users set the flag to ON and reset it to OFF.
Users set the flag ON and reset it OFF.
The flag is refreshed every scan cycle.
The flag is refreshed every scan cycle.
AH5×0
SM1790~SM1805
The flag is ON when an error occurs in the corresponding
communication port.
The flag is refreshed every scan cycle.
AH5×0
SM1806
The flag is ON when the Ether Link function of the corresponding
communication port is enabled.
The flag is refreshed every scan cycle.
The flag is refreshed every scan cycle.
AH5×0
SM1808~SM1823
The flag is ON when the Ether Link function of the corresponding
communication port is enabled.
The flag is refreshed every scan cycle.
The flag is refreshed every scan cycle.
SM1912
The flag is refreshed every scan cycle.
Users set the flag ON and reset it OFF.
The flag is refreshed every scan cycle.
User define. The flag is refreshed, after the transmission is done.
The flag is refreshed when the instruction EMDRW is executed.
The flag is refreshed when the instruction EMDRW is executed.
SM2003
The flag is refreshed when the instruction EMDRW is executed
and an error occurs.
SM2004
The flag is refreshed when the instruction EMDRW is executed
and there is a response timeout.
The flag is refreshed when the instruction EMDRW is executed.
User define. The flag is refreshed, after the transmission is done.
The flag is refreshed when the instruction EMDRW is executed.
The flag is refreshed when the instruction EMDRW is executed.
SM2009
The flag is refreshed when the instruction EMDRW is executed
and an error occurs.
SM2010
The flag is refreshed when the instruction EMDRW is executed
and there is a response timeout.
The flag is refreshed when the instruction EMDRW is executed.
User define. The flag is refreshed, after the transmission is done.
The flag is refreshed when the instruction EMDRW is executed.
The flag is refreshed when the instruction EMDRW is executed.
SM2015
The flag is refreshed when the instruction EMDRW is executed
and an error occurs.
SM2016
The flag is refreshed when the instruction EMDRW is executed
and there is a response timeout.
The flag is refreshed when the instruction EMDRW is executed.
To Next Page
Loading...
