What does HW Connect Fail mean on a Delta C1000?
If your Delta Inverter displays 'HW Connect Fail', it indicates: * A wrong AC connection. Check the AC connection based on the manual. * A detection circuit malfunction. Check the detection circuit inside the inverter.
What causes PID Relay Fail on Delta C1000?
The PID Relay Fail error on your Delta Inverter is caused by PID Relay detection circuit malfunction. Check the detection circuit inside inverter.
Why is the AC voltage high on my Delta Inverter?
A high AC voltage on your Delta Inverter can occur for several reasons: * The actual utility voltage is over the OVR setting. To resolve this, check the utility voltage on the inverter terminal. * The utility voltage is over the Slow OVR setting during operation. In this case, check the country and grid settings. * An incorrect country or grid setting is in place. Verify and correct the country and grid settings. * There is a detection circuit malfunction. Inspect the detection circuit inside the inverter.
What to do if AC frequency is high on Delta Inverter?
If the AC frequency is high on your Delta Inverter, it could be due to a few reasons: * The actual utility frequency is over the OFR setting. Check the utility frequency on the inverter terminal. * The country setting is incorrect. Verify the country setting. * There is a detection circuit malfunction. Inspect the detection circuit inside the inverter.
What to do if AC voltage is low on Delta Inverter?
A low AC voltage on your Delta Inverter might be caused by: * The actual utility voltage being under the UVR setting. Check the utility voltage connection to the inverter terminal. * An incorrect country or grid setting. Verify the country and grid settings. * Wrong AC connections. Inspect the connection in AC. * A detection circuit malfunction. Check the detection circuit inside the inverter.
What to do if AC frequency is low on Delta Inverter?
If the AC frequency is low on your Delta Inverter, consider these potential causes: * The actual utility frequency is under the UFR setting. Check the utility frequency on the inverter terminal. * An incorrect country setting. Verify the country setting. * A detection circuit malfunction. Inspect the detection circuit inside the inverter.
What to do if there is no grid on Delta Inverter?
If your Delta Inverter shows 'No Grid', it may be due to: * The AC breaker being OFF. Switch on the AC breaker. * No voltage on the AC side. Provide AC voltage to the output node of the inverter.
What causes Solar1 High error on Delta C1000 Inverter?
The 'Solar1 High' error on your Delta Inverter can be triggered by: * The actual PV array voltage being over 1000Vdc. Modify the PV array setting to ensure the Voc is less than 1000Vdc. * A detection circuit malfunction. Check the detection circuit inside the inverter.
Why does my Delta C1000 Inverter show Insulation error?
An 'Insulation' error on your Delta Inverter may occur because: * The PV array insulation resistance setting differs from the display setting. Check the display setting. * Large PV array capacitance is present due to a moist PV array, affecting measurement accuracy. Dry the PV panel if necessary. * A detection circuit malfunction. Inspect the detection circuit inside the inverter.
What causes Grid Quality issues with Delta C1000 Inverter?
Grid quality issues with your Delta Inverter can arise from a non-linear load in the grid near the inverter. The grid connection of the inverter needs to be far away from non-linear load if necessary.
General| Control Mode | V/F, Sensorless Vector |
|---|---|
| Overload Capacity | 150% for 60s, 200% for 3s |
| Communication | RS485 |
| Protection | Over-voltage, Over-current, Under-voltage, Overheat, Short-circuit, Ground fault |
| Operating Temperature | -10°C to +50°C |
| Cooling | Forced air cooling |
To Next Page
